![]() Stecker aus der Dose gezogen.) In diesem Zustand läuft nur noch die über eine Lithiumbatterie versorgte Echtzeituhr (RTC, Real Time Clock) des Computers weiter. die Stromversorgung ist komplett unterbrochen (Schalter am Netzteil bzw. Neben diesen Sleep States gibt es noch den Zustand, dass der PC „stromlos“ ist, d.h. (Shutdown) Only the standby circuit of the power supply / mainboard remains active. for Wake On LAN) - This state is called "hibernation". Only the standby circuit of the power supply / mainboard remains active. The information contained in the working memory (RAM) is written to the hard disk (under Windows: C:\hiberfil.sys) and read from there again when the system is switched on. S4 - The system is switched off almost completely. This mode is often called "Standby" or "Suspend to RAM". The RAM continues to be supplied with power and refreshed. S3 - Like S2, but additionally some chips on the mainboard or plug-in cards (e.g. The RAM is still supplied with power and refreshed. Use the Wake on LAN tab to configure: An immediate WOL message can be sent to the Display for testing purposes using the Display row menu and selecting Wake on LAN. Use the row menu for the chosen Display and select Edit. S2 - Like S1, but the processor and possibly some system buses are switched off. Click on Displays from the main CMS menu. S1 - Processor and system buses are stopped. S0 - Power On / Working (switched on, normal operation) The ACPI (Advanced Configuration and Power Interface) defines 6 sleep states. For example, if the client address is 192.168.1.12, the broadcast address used in the packet would be 192.168.1.255.The target device of the wake up signal must be in a defined "sleep state", more precisely in a "sleep state" S3, S4 or S5. It may be necessary to change the address to broadcast the packet to the whole network. If an IP address is specified in the magic packet, then the network switch may not properly broadcast it to the whole network.Confirm that the MAC address used in the magic packet matches the MAC for Ethernet 1 on the client system.Confirm that the client system can be pinged by the system that is sending the magic packet.These settings can override the BIOS in Windows 8 or Windows 10. ![]() Check the NIC driver properties in Windows and ensure that WOL is enabled there.There is some interaction between the BIOS settings and the NIC driver settings in Windows 8. It may be necessary to boot to the Windows desktop after changing the BIOS settings in order for them to be properly applied.This power saving setting turns off the NIC. Ensure that Deep Sleep is disabled in the BIOS (not applicable to all systems). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |